Sliding Screen Doors

Pre-hung interior doors have a dimension, a 3/4inch gap between the bottom of the door and the ground allows. Modern interior doors are made of wire-type core with a solid wood frame. This difference is to leave the door, freely and without binding effect on the swing finished floor. If the door does not fit the rough opening height, the door must be cut to fit the opening.

When the entire lower section is cut to shorten the door, the bottom, which was cutBegins to be used again to close the cavity door.

1) After you remove the door from its hinges. Calculate the thickness of the finished floor, add 3 / 4 inches to this measurement.

2) transfer that measurement to the bottom of the door. Both lower limbs measuring and writes a line across the width of the door. (With a sharp utility knife).

3) Measure the distance from the end of the guide plate seen on the blade.

4) Now that the transfer of measurement anda mark on both sides of the door precisely described by the mark and clamp a straight edge. The ruler serves as a guide for the circular saw resting against the cut at the moment.

5) Saw the bottom of the door. The hollow core door may be exposed, will be made after the cut. If so, you must replace the lower frame.

Substituting 6) The lower frame, chisel cutting of veneer from the cut-off frame, fits perfectly between the side walls of the door. Limboth sides of the cut-off frame and paste it into the slot. Wipe the excess glue and allow to dry, preferably overnight.

There you have it folks! It was not very difficult. Was?

Tommy Tooltime

Related posts:

1. Guide to Installing a New Door
2. Instructions for installing a new door
3. How to Fix an Aluminum Sliding Door
4. Installation and replacement of doors
5. Replacing Your Sliding Glass Door Rollers